Item no. LM34-PSH-5000
From a single hand-held remote, direct 5 functions on your LumberPro’s sawhead: set the depth-of-cut, control the throttle, activate the blade lube system, engage the clutch, and power the carriage through the cut… all while standing comfortably at the head of your mill.
Controlled by a 3-way momentary switch on the remote, the power drive motor with chain-drive system positively powers your saw carriage along the log deck, through the cut… and back. Adjust your feed rate, on-the-go, thanks to the speed-adjusting dial integrated right into the
remote control… speed up, or slow down, as you’re cutting, so you get smooth boards, every time.
The control panel is programmed to make all your power-feed transitions smooth—Stop◄▬►Forward, Stop◄▬►Reverse, and Forward◄▬►Reverse. From the same remote, activate the dedicated 3-way momentary switch to raise and lower the sawhead.
Add a chain kit for each 4-foot bed extension (Item No. LM34-PSH-5020)
Power sawhead only: powers your depth-of-cut adjustment only (Item No. LM34-PSH-5030)